Spurred on by getting a bunch of meter movements off of fleebay, I finally got round to cleaning up and preparing my early AVO 8 MK1 for repair.
It’s all cleaned up as far as the front bit is concerned, got to wind a shunt resistor which is burnt out, but that’s no problem and finally clean up the back case, which someone has varnished with something awful.
Fingers crossed there’s a good enough coil on the ones coming to finally get this old girl going again.
UPDATE- Well there was quite a few that were okey, as far as working, most of them were a bit bent up but I selected one that did the job and progress is, well, progressing 😀
Will update with photo’s when I get time and when I’ve got a bit further…
Ast..